Sous Vide Recipes and Shit

[hornbri 1508]

got a searzall a couple weeks ago. Did SV steaks this weekend and finished them with the searzall. WOW so easy and they were perfect. 

[NoName 17146]

1 hour ago, hornbri said:

got a searzall a couple weeks ago. Did SV steaks this weekend and finished them with the searzall. WOW so easy and they were perfect. 

really considering picking one up...have been for months

[C-Man 27777]

On 2/18/2019 at 10:39 AM, luke duke said:

 

You get much better gifts from your in-laws than I do.
1st set of in-laws - Klose pit
2nd set of in-laws - Sous vide setup
The bar is set pretty high for the 3rd set.

 

In reality, the Klose came from my parents -- but point taken. There will *not* be a 3rd set! LULZ

[hopkinsnhorns 533]

Anyone ever ever do roast beef in one of these?  I got a rump roast for cheap from HEB and figured I'd give it a shot with the old sous vide.

[BottleRocket 659]

Two tenderloins and a microphone.

[Anastasis 23715]

Mothers Day sous vide.

Bone in pork rib roast, seasoned with salt pepper thyme and garlic

138 degrees for about 9 hours. 

Pat dry, give quick pass with searzall to dry further, into oven @525 for a few minutes to brown.  Finish with further spot searing as needed.

Dripping from bag reduced with some butter salt and pepper and drizzled over.

Was great, moist and delicious. would do it at 135 next time. 

 

[C-Man 27777]

Mothers Day sous vide.
Bone in pork rib roast, seasoned with salt pepper thyme and garlic
138 degrees for about 9 hours. 
Pat dry, give quick pass with searzall to dry further, into oven @525 for a few minutes to brown.  Finish with further spot searing as needed.
Dripping from bag reduced with some butter salt and pepper and drizzled over.
Was great, moist and delicious. would do it at 135 next time. 
 

Looks good. Thought I read you shouldn’t sous vide with raw garlic in the bag for some reason. Maybe it depends on the temp??

[Goofyboy 3432]

“So if you are including raw garlic in your sous vide bag you should be adding it like you would normally use raw garlic to finish a dish. It'll have a sharp, pungent flavor and not the usual cooked garlic flavor.”

It’s a flavor thing.

[Anastasis 23715]

Yeah, I have read that wrt garlic.  I use less herbs and garlic in longer cooks than I would otherwise (i use a shit load of garlic in my cooking generally).  I don't notice any off putting flavors.

[Anastasis 23715]

So a while back I ordered a case of lamb ribs.  Tried the first couple out by throwing them on the smoker, and they just didn't turn out right. Too dry and stringy.  Never had this same problem with lamb breast. Figured that they need a moist cooking method to loosen up.  

Sous Vide @ 160 for ~24h. Salt, pepper, onion and garlic powder seasoning before they went into the bag.

Finished on smoker for a couple hours to get some smoke and color. Basted with lemon juice, olive oil, onions, cider vinegar mop sauce. Finished with squeeze of fresh lemon.

The rest of the case is going to get this treatment.

[luke duke 6449]

160?

[Anastasis 23715]

4 minutes ago, luke duke said:

160?

Yeah. The internet convinced me that collagen and connective tissues need the higher temp to break down fully.  I think that shanks benefit from higher temps too, 145-150+ range.

If we were talking a chop or rack, I'd go  130 or even a couple degrees lower. Like below double cut. 

[Dr Fear 1290]

I am going to make the jump.  Which one should I get?  I have been told I want the extra power of 1100 watts.  I also want to be able to use it in a regular pot and some sort of custom cooler container/cooler setup for bigger stuff that I will make.

[sidis 10012]

i have a mega-machine that i'm not going to bother even talking about but also have a joule.  i've been happy with it.  does what it is supposed to.  don't think you can go wrong between it or the anova.

[Goofyboy 3432]

I have a Sous Vide Supreme. It’s been great.

[Mo Horn 8937]

I have a Joule and it works great. It's got a magnet on the bottom that will stick to a stainless pot. I've used it to do one hour cooking and 7 hours. I've not tried it in a big ice chest / cooler, but I think it would work. 

[Anastasis 23715]

Anova, 800W I think. I guess more power is always good but I've never had any problem hitting the temp range I need. Cooking in a 12qt tub. 

 

[Anastasis 23715]

1 hour ago, sidis said:

i have a mega-machine that i'm not going to bother even talking about

Bother.

[sidis 10012]

polyscience 45 liter integrated system.

[Anastasis 23715]

10 minutes ago, sidis said:

polyscience 45 liter integrated system.

Let me get this right. You have a 10 gallon sous vide set up.

LOL. That's fucking awesome.

[elfenix 34741]

*12 gallon

[Dr Fear 1290]

58 minutes ago, Mo Horn said:

I have a Joule and it works great. It's got a magnet on the bottom that will stick to a stainless pot. I've used it to do one hour cooking and 7 hours. I've not tried it in a big ice chest / cooler, but I think it would work. 

Is the clip on the Joule removable? 

[sidis 10012]

2 hours ago, Anastasis said:

Let me get this right. You have a 10 gallon sous vide set up.

LOL. That's fucking awesome. 

because reasons and stuff...

[sidis 10012]

1 hour ago, Dr Fear said:

Is the clip on the Joule removable?  

i have never tried to...not sure why you would.  it is ideal to have for sticking into a deeper containers.  honestly, the rubbermaid 12 qt with the joule-unique cover is an ideal rig.  or the anova.  you really can't go wrong between the two.

[Dr Fear 1290]

i have never tried to...not sure why you would.  it is ideal to have for sticking into a deeper containers.  honestly, the rubbermaid 12 qt with the joule-unique cover is an ideal rig.  or the anova.  you really can't go wrong between the two.

I looked on Amazon and their site and it was hard the even confirm the existence of the clip. None of the pictures had it in it.

[sidis 10012]

2 hours ago, Dr Fear said:

3 hours ago, sidis said:

i have never tried to...not sure why you would.  it is ideal to have for sticking into a deeper containers.  honestly, the rubbermaid 12 qt with the joule-unique cover is an ideal rig.  or the anova.  you really can't go wrong between the two.

I looked on Amazon and their site and it was hard the even confirm the existence of the clip. None of the pictures had it in it.

clip is definitely there...no doubt about it.

[Sam Lin 3597]

8 hours ago, Mo Horn said:

It's got a magnet on the bottom that will stick to a stainless pot.

Note this depends on the specific stainless of the pot, not on the magnet. Some grades of stainless are magnetic, other grades are not.

[C-Man 27777]

The Anova can be used in a cambro container and in pots. I think the Joule is probably a better device but it costs a bit more.

Read somewhere back when I first got my machine that it was better to cook in things other than metal pots, i.e. the cambros or something similar.

[elfenix 34741]

The Anova can be used in a cambro container and in pots. I think the Joule is probably a better device but it costs a bit more.

Read somewhere back when I first got my machine that it was better to cook in things other than metal pots, i.e. the cambros or something similar.

Metal pot takes more energy to heat and loses more to the environment.

 

I've read that the joule is more accurate than the anova. Next cook I'll check the water temp with my thermapen to see where it is relative to my anova.

[Anastasis 23715]

My Anova has always been within a tenth or two from my thermapen. 

Edited July 4, 2019 by Anastasis
Happy 4th

[Grimas 674]

Picked up some beef short ribs from HEB already vacuum packed.  Has anyone tried SV ribs “as-is” (without opening, seasoning and then repackaging)? The plan is to go 36 hours but I hate pulling out the vacuum sealer if I can avoid it because mine is a pain to always get a good seal.seal.  I know the effort of adding seasoning before sealing should be worth it but has anyone tried to SV without seasoning the meat before cooking?

[NoName 17146]

On 8/10/2019 at 11:10 AM, Grimas said:

Picked up some beef short ribs from HEB already vacuum packed.  Has anyone tried SV ribs “as-is” (without opening, seasoning and then repackaging)? The plan is to go 36 hours but I hate pulling out the vacuum sealer if I can avoid it because mine is a pain to always get a good seal.seal.  I know the effort of adding seasoning before sealing should be worth it but has anyone tried to SV without seasoning the meat before cooking?

best bet is to go to one of the large SV facebook groups and ask there - much higher chance someone has either tried before just due to group size. 

[Grimas 674]

On 8/12/2019 at 10:27 AM, NoName said:

best bet is to go to one of the large SV facebook groups and ask there - much higher chance someone has either tried before just due to group size. 

Thanks for the advice... I ended up cutting into 2 rib portions, added a Demi glacé/trinity mix to each bag and cooked for 48 hours at 167 and served over polenta.  Wife complained it was “too rich” but kids and I sucked the beef down... Happy dog got a bone as well...

Edited August 14, 2019 by Grimas

[elfenix 34741]

do y'all put your food in and then let water come to temp, or heat water then put food in?

[Chewbacca 7828]

do y'all put your food in and then let water come to temp, or heat water then put food in?

Heat water first

[Mo Horn 8937]

2 minutes ago, elfenix said:

do y'all put your food in and then let water come to temp, or heat water then put food in?

Heat the water first. 

[Sam Lin 3597]

If you're doing a long cook, it doesn't matter at all. You can also start the food directly from frozen, no issue there either.

[NoName 17146]

9 hours ago, elfenix said:

do y'all put your food in and then let water come to temp, or heat water then put food in?

if you are cooking something for a couple of hours, i get it to temp then add baggies

if you are doing something crazy long like 18-24 hour cook, i can't imagine it matters. 

Edited August 22, 2019 by NoName

[elfenix 34741]

i ask because i'm annoyed that the timer on the anova app doesn't start when the temp is reached. 

[SydneyCarton 49475]

21 minutes ago, elfenix said:

i ask because i'm annoyed that the timer on the anova app doesn't start when the temp is reached. 

I had that issue. Also my anova decided to stop recognizing my phone over bluetooth for no reason. 

[Anastasis 23715]

yeah, the app in my experience is worthless. set the temp manually. let it come to temp. drop in the food. look at the clock. 

[Loco 3754]

1 hour ago, Anastasis said:

yeah, the app in my experience is worthless. set the temp manually. let it come to temp. drop in the food. look at the clock. 

This

[elfenix 34741]

i once accidentally switched recipes without realizing it because i looked at the app while walking the dog.  most cooking i've been doing without the app lately, but for some reason decided to fire it up the other day (think i was looking for chicken vindaloo).

[C-Man 27777]

Use mayo for the post-bath sear?

https://anovaculinary.com/mayo-sear/?utm_source=social&utm_medium=nonpaid

[Mo Horn 8937]

Absolutely going to try this

[elfenix 34741]

i had that idea a couple of weeks ago but hadn't gotten around to trying it yet.

[Planet Houston 4950]

9 hours ago, C-Man said:

Use mayo for the post-bath sear?

https://anovaculinary.com/mayo-sear/?utm_source=social&utm_medium=nonpaid

If this works as advertised, you need all the reps

[C-Man 27777]

1 hour ago, Planet Houston said:

If this works as advertised, you need all the reps

Give it a shot! I’m curious. I have a Searzall so somebody will need to tell me this is great before I slather Mayo on a $35 piece of meat. (And I love mayo.)

[Planet Houston 4950]

I have my sous vide and cast iron method as good as I can get with the equipment I’m working with (heating the shit out of the skillet over an outside gas burner, which maxes out at 520 or so), and I can’t get the sear I want. Been wanting to get a searzall, but I’m about to get a serious upgrade in outdoor cooking equipment and I want to try searing it at closer to 650 before going with the searzall. 

But until that happens, I’ll try this method and will report back. 

[C-Man 27777]

1 hour ago, Planet Houston said:

I have my sous vide and cast iron method as good as I can get with the equipment I’m working with (heating the shit out of the skillet over an outside gas burner, which maxes out at 520 or so), and I can’t get the sear I want. Been wanting to get a searzall, but I’m about to get a serious upgrade in outdoor cooking equipment and I want to try searing it at closer to 650 before going with the searzall. 

But until that happens, I’ll try this method and will report back.